Technical FAQs

Ask a Question

Can the lugs on a QB type breaker be removed or replaced?
Product Line: Circuit Breakers PowerPact Q Environment: Electrical Distribution Equipment Resolution: No, the lugs not removable or replaceable.  
Are the Powerpact H, J, and L breakers CE marked?
Product Line: Circuit Breakers PowerPact H, J, and L Environment: Electrical Distribution Equipment Resolution: Yes they are. It shows CE on the lower...
When did the LC series number change to Series 3? The mag trip level of the LC and LI circuit breaker are different than they were a few years ago.
Product Line: Circuit Breakers Legacy Type Environment: Electrical Distribution Equipment Resolution: The date of the change was July 2002. Date code...
Make a backup of ClearSCADA Mobile configuration.
Configuration of ClearSCADA Mobile Server can be backed up by making a copy of the MobileConfig.sdf configuration file located in C:\ProgramData\Schneider...
Locate Log Files for ClearSCADA Mobile
This article briefly explains where necessary information can be obtained from to help troubleshoot issues related to ClearSCADA Mobile. Please go...
Common issues found in ClearSCADA Mobile
This article goes over some common issues that one might encounter when configuring ClearSCADA Mobile and provides some basic steps to troubleshoot...
Video: What causes an StF fault on an Altistart 22 Soft Starter?
Issue: Troubleshooting StF Fault on Altistart 22 Product Line: ATS22 Soft Starter Environment: All models Cause: The StF fault means the starter has...
Why time stamps reported in a Crystal Reports report are different from ViewX
You may notice a difference in time stamps reported in your Crystal Reports report when compared to the similar data displayed in ViewX or WebX clients....
Powerpact L Frame Lugs; number of conductors and size
Issue: What are the lug kits available for Powerpact L and what wire sizes do they accept? Product Line: Circuit Breakers Environment: Powerpact L...
Video: What would cause the ATS48 to show RDY even with a run command?
Issue: Troubleshooting a RDY (ready) status following a run command on the Altistart ATS48 Soft Starter by verifying supply voltages and wiring with...
Results 21 - 30 of 100