Technical FAQs

Ask a Question

Video: How to remove a Qwiklet tab from a QO or Homeline Qwik-Grip load center?

Issue:
Load Center Application

Product Line:
QO and Homeline Qwik-Grip Load Centers

Environment:
QO and Homeline Qwik-Grip Load Centers

Cause:
Application

Resolution:
Qwiklet tabs are removed in order to install cable in the Qwik-Grip Inserts.
The attached video is ONLY to supplement the INSTRUCTIONS that come with the Qwik-Grip load centers. PLEASE make sure to read the instructions and all the below Safety Information that is located in the instructions BEFORE working on any electrical equipment.




Make sure to turn OFF ALL Power supplying the equipment and verify the power is OFF using a properly rated voltage sensing device, BEFORE working on or with electrical equipment. 

1) Once all Safety steps are followed, begin the remove of the Qwiklet tabs following the directions that come with the Qwik-Grip load centers.
2) To remove a Qwiklet Tab simply grab one Qwiklet tab with
needle-nose pliers or similar tool and twist the Qwiklet tab out. 

NOTE: PLEASE READ ALL INSTRUCTIONS AND SAFETY INFORMATION THAT COME WITH THE QWIK-GRIP LOAD CENTERS AND NEVER WORK ON ENERGIZED EQUIPMENT.

Was this helpful?
What can we do to improve the information ?