Technical FAQs

Ask a Question

What causes a 'Network Skipped' message in ProWORX?

There are several reasons for the 'Network Skipped' message being displayed online.
- Are all segments scheduled?
- Is the PLC running in optimized mode?
- Hot standby system?
- SKP blocks used in Ladder logic?
- Modbus communication. This can be a MB timeout. Jumper out the handshaking on the cable.
- If this occurs in an Equation network, it could be a old Proworx Nxt bug. If the value in the Equation Network register goes below 0, Proworx NxT displays this message.


Was this helpful?
What can we do to improve the information ?