Technical FAQs

Ask a Question

Configuring Ethernet Communications on Scadapack 535E


The following procedure describes how to configure an Ethernet communications link between Eth1 on the rPAC and the SCADAPack E Configurator computer.
To Configure an Ethernet Communications Link

  1. Plug the Usb cable from the computer to the USB port of the scadapack 535E to write configurations.
  2. Using a CAT5 UTP cable, connect Eth1 on the rPAC to a switch, a hub, or a wall outlet for your LAN.
  3. Confirm that the SCADAPack E Configurator computer is also connected to the LAN.
  4. If the SCADAPack E Configurator software is not already running, launch it by selecting Start > All Programs > Schneider Electric > SCADAPack E > SCADAPack E Configurator and choosing your rPAC.

  5. The SCADAPack E Configurator main window opens as shown below.

  6.  

SCADAPack E Configurator Main Window
  1. In the SCADAPack E Configurator software, expand the TCP/IP folder then select the TCP/IP property page.