Start here for access to our Knowledge Base to get answers to over one hundred thousand questions online in seconds.Find Answers
...See what we've been doing in some of our major markets.Find your Location
Access tailored services, 24/7 self-service and expert help. Anywhere, anytime, any project.Discover now
Everything you need to know about our IoT technology backbone.Learn more
Explore our global offerings or select your country from one of our five regions.Global
Découvrez nos offres globales ou sélectionnez votre pays dans l’une de nos cinq régions.
Need to bench test an ATV900 series drive but only have an undersized motor available. What parameters in the drive need to be changed in order to run the drive on an undersized motor?
ATV600 / ATV900 series process drives.
All models, All serial numbers.
Information not available in current literature.
Note that this is for testing purposes only and can not be used as a permanent configuration.
Select control law to CTT = UF5pt
It is not necessary to enter the 5 points.
Enter name plate in cos MPC = cos
Adjust FRS parameter to match the motor rated frequency in Hz.
Adjust UNS parameter to match the voltage rating of the motor, not the voltage of the incoming 3 phase power.
DO NOT PERFORM AN AUTOTUNE.
Reduce current limitation : CLI = FLA of motor, or as close to it as you can adjust it.
Reduce IR compensation : UFR=0
Slip compensation to SLP= 0
Reduce the inertia factor : SPGU = 0
Disable the boost BOA = Inactive
This should allow you to run the drive on an undersized motor for testing purposes, such as verifying you control scheme. Do Not use this configuration as a permanent configuration as motor damage could occur.