Technical FAQs

Ask a Question

My 9070 Type T or TF industrial control transformer has 4 terminals on both the primary & secodary, but only markings on the wiring diagram of H1and H2 on the primary and X1 and X2 on the secondary. Which terminal do I use?

Issue:
Terminals on 9070 Series Industrial Control Transformers

Product Line:
LV Transformers

Environment:
Applies to Industrial Control Transformers by SquareD/Schneider Electric

Cause:
9070 Industrial Control Transformers use screw connections for primary and secondary

Resolution:
The nameplate of your Square D 9070 Type T or TF Industrial Control Transformer clearly marks out that the outside terminals of each side are used for the customer installed wire connections. Square D/Schneider Electric makes a standard 4 or 6 terminal block for various Transformer designs for commercial cost effectiveness. With only two terminals being used, it is standard practice for it to always be the outside terminals. Several different Transformer voltage and wiring arrangements are shown in the Industrial Control Transformer catalog, document # 9070CT9901.


CTA-ID : 16048
Was this helpful?
What can we do to improve the information ?